Been trying to get added here for something like 2 years!
My name's Austin, thanks for the add!
I own a 76 Celica GT thats got tons done to it. I'm also a student at ASU and president of the car club there, Street Refined.
Here's my build list:
Engine/ Ignition/ Fuel:
- 20R 2.2L (30 thousandths overbore), 2190cc, 8:4:1 compression, aluminum head/block
+.030 hypereutectic pistons from LCE
High performance dual valve springs by Toyhead
Aluminum racing rocker arm assembly with Drilled Shafts by Toyhead
FelPro head gasket
Upgraded bronze valve keepers by Toyhead
High performance bronze valve guides by Toyhead
New valve seals by Toyhead
Stainless steel oversize valves (intake 43mm x 8mm x 115.4mm, exhaust 43mm x 8mm x 115.4mm)
Toyhead Cam No. 801-282 (282', .5/.433 lift)
EGR blockoff by LCE
LCE Master Rebuild Kit
Long tube racing header by OBXr (4x1.5”:1x3”)
2.5" performance exhaust with Dynomax muffler, catless from factory
MSD Streetfire ignition
Pertronix electronic point converter
Centerforce throw-out bearing and pilot bearing
Centerforce II clutch
Weber 38 DGES carb, tuned by Techno Classic USA
Aftermarket high flow fuel pump
Holley fuel regulator
Jeep high flow fuel filter(Used for return line to pump)
Full port and polish on head w/ port match
Audio System:
- 4x 400W Rockford Fosgate punch amp
2 5” Infinity speakers by Harmon Kardon
2 6”x 9” Infinity speakers by Harmon Kardon
Rockford Fosgate Punch 225d amp mono bridged for subwoofers
2x Pioneer 12.5” TS-W304C subwoofers
Custom built woofer box with two separated enclosures @ 1.2 cu ft each
All wiring/ fusing wire tucked and run under carpet
Alpine stereo deck
- Custom adjustable front control arms from Techno Toy Tuning
KYB AGX 4 level selectable dampers, front
QA1 82 series Aluminum Threaded Twin Tube Shocks, rear
QA1 coils (rate @ 8k/6k) (7ht350 & 7ht450)
Godspeed ae86 front sway bar upgrade (25.13mm)
Custom drop endlinks by Techno Classic
Custom milled 45mm RCAs by Techno Classic
Custom milled camber plates by Techno Classic
Custom milled perches and top hats by Techno Classic
QA1 CK8201 coil over kit for 82 series (Aluminum sleeve, Spring cap, Spring seat, adjuster nut, Wire ties, Spring cap retainer pin, Jam nut, Snap rings), assembled and modified by Techno Classic
Corner balanced by Techno Classic
- 15x7.5” Gram Lights 57v by Rays Wheels
205/50/15 Yokohama S Drive
Exterior:
- Custom fiberglass rear spoiler by Fauxau2
1974 Smiley Bumpers, front and rear; re-chromed
Rolled fenders (all four)
All Celica insignias intact (steering wheel, rear side panels, trunk, original shift knob)
Original GT grille from 1976
JDM mirror
Original body panels & hood from 1976
New paint; GM white; originally green (as seen in the engine bay)
- Fully restored seats and side panels
New carpeting and headliner
Original dash, center console, sail panels and steering wheel from 1976
Check out my build page for pics, write-ups and more at:
http://www.facebook.com/AustinsCelica/
